2016-05-01 04:15
deflections翻译
挠度
音标读音
英式:[dɪf'lekʃnz]美式:[dɪf'lekʃnz]
基本意思
n.(尤指击中某物后)突然转向,偏斜,偏离( deflection的名词复数 )
形近的词
变形
例句
- Novel system for measuring bridge deflections based on laser and video
基于激光和视频的桥梁挠度测量新系统
- Vertical elements carry sufficient load through cantilever action to produce cantilever deflections equal to arch deflections.
垂直杆件则借悬臂作用产生和拱挠度相等的悬臂挠度,来承担足够的荷载。
- We may use the plane stress analysis for determining deflections in the midplane of the beam.
我们可以用平面压力的分析方法来确立梁中间面的挠度。
- Formulas for calculating deflections and internal forces of frame-Shearwall structural systems under various loads are deriven.
推导了多种荷载情况下结构内力和位移的计算公式。
- There are deflections in varying degree between the experimental curve and the theoretical calculated curves.
实验曲线与两条理论曲线都有不同程度的偏差。
- The influences of the welding residual deflections and stresses on the plating vibration were discussed.
探讨了焊接残余变形、残余应力对船体板振动频率的影响。
- Experimental results indicate that the cracks weaken the strength of slabs, lower their stiffness, and induce the deflections of slabs beyond limit.
试验结果表明,支座边的裂缝严重削弱了板的承载力,降低了楼板的刚度,导致楼板的挠度过大。
- And the effects of elastic contact deflections on convergence and impact responses are discussed, in which the elastic contact deflection is considered to be a spring.
用弹簧模拟接触变形,分析了接触变形对收敛性和碰撞响应的影响。
- They observed the deflections of the particles by allowing them to fall on a fluorescent screen.
他们让粒子落在荧光屏上以观察他们的偏移。
- The deflections of the vertical happen to be known in this case ( see below).
垂直偏斜碰巧在此例中有证明(看下图)。
- Measuring the Bending Stiffness of Paper by Using the theory of Large Deflections of a Cantilever Beam
用悬臂粱的大挠度理论测定纸的抗弯刚度
- The effects of deflections are evaluated during the process of calibrating the balance.
变形影响是在天平校准的过程中测量的。
- This renders the bearing like other self-aligning bearings, impervious to misalignments and shaft deflections.
有这种装置的轴承就像自调整轴承,可以避免误差和轴倾斜。
- The pace analyzes the current pre-arched calculation and installation method based on the relative deflections, and proposes a new absolute deflection method.
本文在对现行的基于相对挠度的预拱度计算设置方法进行分析后,进而提出了新的绝对挠度法。
- Analysis to Large Deflections of Elastic Cantilever Beam with Constraint under Uniformly Distributed Load
均布载荷下变形受约束悬臂梁弹性大变形分析
- When aerodynamic solution and structural deflections are both converged, the aerodynamic characteristic of the elastic wing is obtained.
将非线性气动力与结构线化机翼弹性变形耦合迭代求解。
- Based on the superposition principle of small deflections, general stiffness model for multi-axis series machine tool was established as physical constrains for tool posture optimization.
在变形叠加基本原理的基础上,对多轴数控机床刚度模型进行了研究,得到了多轴数控加工刀具姿态优化的物理约束条件。
- The associated permitted deflections shall be included in the contract documents.
相关许可挠度应当包含在合同文件中。
- The test results showed that the fracture deflections of the composite coatings and the fractal dimensions of the fractured surfaces decreased with increasing the contents of hard phases.
测量了多相材料复合涂层的断裂挠度和断口表面的分形维数,分析了复合涂层的断裂特征结果表明:随着硬质相增加,复合涂层的断裂挠度和断口表面的分形维数降。
- The major application of these data is to define the control deflections required to stabilize the vehicle.
这些数据的主要应用是确定稳定飞行器所需要的控制偏角。
- In geometric nonlinearity, the effects of instability produced by axial forces, the bowing of the deformed members, and finite deflections have all been included.
在几何非线性的影响下,所产生不稳定的轴向力、弯曲变形产生的弯矩,以及有限制的偏移量均包括在内。
- Static Analysis of Plates Supported by Elastic BeamsUsing the Coupling of BEM and Analytical Beam Deflections
边界元与梁的挠度解析式耦合分析弹性支承板
- But, more significantly, the overturning moment and the shear deflections produced by lateral forces are much larger and must be carefully provided for.
更重要的是侧向里所产生的倾覆力矩和剪力变形要大的多,必要谨慎设计来保证。
- Change in the magnitude of the cutting force resulting in changes in machine and workpiece deflections causing workpiece dimensions to change.
切削力的大小改变,导致机器变化和工件倾斜,使工件尺寸变化。
- Equations are established based on the principle of deflections consistency.
根据板簧变形协调原理,导出相应的方程。
- However, while some building codes provide methods for estimating shear wall deflections, these methods are not adequate for shear walls without hold-downs.
尽管有些国家的建筑规范中已给出了估算木结构剪力墙侧向变形的方法,但这些方法并不适用于无抗倾覆锚固件木结构剪力墙。
- Though it is derived from the method of forces, it is also suitable for the slope and deflections method and that of moment distribution for solving statically indeterminate structure.
这个方法虽然是由力法推导出来的,但也适用于用位移法、力矩分配法等求解超静定结构时的情况。
- For example, ball and roller bearings can be of the self-aligning type to accommodate shaft misalignment and deflections.
例如,滚球轴承和滚珠轴承属于自行调整式,能调适轴心差和轴偏转。
- The effects of some parameters, such as the plate thickness, radius of the filled foundation, on the maximum deflections and stress, are also investigated.
最后研究了盖层厚度、填充半径对位移、应力的影响规律。
- Kokyunage is a great technique to use in conjunction with arm deflections in Randori.
Kokyunage是一个伟大的技术,用手臂一起在Randori挠度。
百科解释
网络意思
变形
挠度
变形量
偏转
偏折