2016-08-19 16:29
restriking翻译
重燃
音标读音
英式:[rɪst'raɪkɪŋ]美式:[rɪst'raɪkɪŋ]
基本意思
v.再打，（尤指以不同印模）再冲制（硬币）( restrike的现在分词 )
形近的词
变形
例句
- Steepness Suppression of Vacuum Restriking Overvoltage by Magnetic Ring
磁环抑制真空重燃过电压的陡度
- It is showed that magnetic rings of amorphous material on a conductor can notably increase its inductance and make effective suppression on the steepness of the vacuum restriking overvoltage.
试验显示，在导线上套上一串非晶材料磁环能够显著增加线路电感，对减小真空开关重燃过电压的陡度是有效的。
- It is developed the restriking die to achieve once the precision of dimension form and position of end-cap.
根据端盖的特殊要求，设计了一副整形模，一次性地达到了制件的尺寸精度和各部形位精度。
- Based on investigation on the situation of type test and conditioning test of switching capacitor using vacuum circuit breaker, this paper analyses the factors that influence on restrike and presents a method to reduce the restriking rate.
根据真空断路器投切电容器组型式试验与老炼试验情况的调查，分析了影响重燃的因素，提出了降低重燃率的方法和对策。
- The stamping process includes punching, bending, irregular flanging, bulging, partial embossing and restriking, etc.
冲压工艺有冲裁、弯曲、不规则翻边、胀形、局部压凸、整形等。
- The neutral grounding method based on manual earthing& dividing current technique is put forward, which makes residual current at fault point low to nearly zero, slow down the muzzle velocity of voltage restoring and restrict its maximum to avoid arc restriking.
提出了基于人为接地分流技术的中性点接地方式，使故障点残流降至接近于零，从而降低了恢复电压的初速度并限制了其最大值，避免接地电弧重燃。
- On the basis of the are volt-ampere characteristics, the ar energy, the restriking voltage on the ar gap and the ar movement in the deion type of arc-chute, a theoretical analysis is made for the influence of power frequency on switching apparatus.
根据电弧的伏安特性、电弧的能量、电弧间隙上的恢复电压和电弧在去离子栅灭弧室中运动等四个方面，从理论上分析电源频率对开关电器的影响。
- From the factors such as contact material, vacuum degree, processing technology and configuration, this paper analyses the causes of high forepart restriking rate of 35 kV vacuum circuit breaker in the closing opening process of capacitor group.
从触头材料、真空度、加工工艺和机构动作等因素分析了35kV真空断路器开合电容器组早期重击穿率高的原因。
- Effect of arc running channel on restriking phenomena of interrupting process in current limiting circuit breaker
电弧运动通道对低压限流断路器开断过程重击穿现象的影响
- By analyzing the investigated model, we can found that restriking phenomena occur which cause arc channel commutate to the contact region.
对断路器测试分析发现，这一现象是由电弧通道转移至触头区引起，而造成电弧通道转移的主要原因是发生在触头区的重击穿现象。
- On the Contact Bouncing and Restriking phenomena in Vacuum Switches
真空开关的触头振动与重击穿现象
- Left and right wheel cowling work piece of automobile were integrated and stretched, then through the work process of restriking, trimming, piercing and slitting, the left and right work piece were separated in the end.
介绍了汽车左、右轮罩两工件整合在一起进行拉伸，然后经过整形、修边、冲孔、剖切等工序，再将左右两工件剖开。
- Restriking Phenomena in Current Limiting Circuit Breaker and Restraining Methods
低压限流断路器开断过程重击穿现象及防止措施
- Electrical tests show that the post arc restriking on the interrupter can be essentially eliminated by interrupting with the current of 150 A several tens times.
电气试验表明，经数十次150A的电弧老炼，可基本消除灭弧室开断后的重击穿现象，老炼效果良好。
- Experiments show that the periods of the contacts bounce to their minimum gap value are in line with the frequently occurence of the restriking.
试验表明，反弹到最小开距的阶段是重击穿出现的频率最高的阶段。
- Restriking Die for Micromotor End-Cap
微型电机端盖整形模设计
- Protection Measures to Restrict Switch Restriking Over-voltage for 35 kV SVC
35kV补偿装置开关重燃过电压的保护措施
百科解释
网络意思